method

1241Currently online
10Today's Reading
20Share Today
Multilingual display

Measurement results, memory and query of Negel upper arm electronic sphygmomanometer

2018-04-23 11:12:10

Measurement results, memory and inquiry of the Negel upper arm electronic sphygmomanometer

Tools/Materials

Nagel upper arm electronic blood pressure monitor

Methods/Steps
1

The measurement results are shown in the figure below: high pressure :128mmHg, low pressure: 78mng, pulse :72 beats/min. The measurement results are automatically saved with the serial number 0, the previous result is stored with the serial number 1, and so on.

2

When there is a measurement error (error E is shown on the sphygmomanometer in the figure below), please take a quiet rest for 3 minutes and then re-measure according to the operation steps in item 6.

3

The Naigle sphygmomanometer can store two sets of measurement results, each group can store up to 120 groups, if 120 groups have been saved, when the 121 group is saved, the oldest measurement results will be deleted, and the serial number will appear for about 1 second before the measurement results are displayed. The latest set of measurements is numbered "0". At the end of measurement or shutdown state, press the [memory] key (as shown in the figure on the right) to view the saved data. Press the [memory] key or [Set] key (as shown in the figure below), and switch to read the memory data.

Matters needing attention

The serial number will appear for about 1 second before the measurement results are displayed. The latest set of measurements is numbered "0".

Recommendation