method

1241Currently online
10Today's Reading
20Share Today
Multilingual display

The wrong way to maintain a car

2018-05-01 11:12:05

The car is no longer just a means of transportation, it is more like our friends, especially male compatriots encountered before the Great Wall oil to gas, especially like the car, so that the car has become an important member of the family. Our love for them is to pay attention to some details, only in this way can we protect our car well and make it go farther and more stable.

Methods/Steps
1

Tire pressure should be moderate

2

When the owner uses the air pump to inflate itself, it should be inflated in accordance with the air pressure stipulated by the home, and the tire pressure label is usually located on the body or the fuel tank cap. Because the tire pressure is too high, the tire ground will be reduced, the tread wear will be aggravated, and the braking effect will be reduced, which will affect the driving safety. Too low tire pressure is not good, too low pressure in addition to affecting driving safety and braking effect, but also accelerate the wear of the tire shoulder, as well as increase the fuel consumption of the vehicle.

3

A car wash can't be like a bath

4

When the weather temperature rises, the frequency of car wash increases, because the dust increases, the body is easy to dirty, so many car owners also want to wash the car as thoroughly as giving themselves a bath. But it should be noted here that we must keep the appearance of the car air conditioning dry, if the car air conditioning is accidentally wet, it will affect the life of the car air conditioning.

5

The oil should be moderate

6

When the owner checks or adds the oil, it should be added according to the scale above the oil scale, the highest oil level can not exceed the upper limit of the scale, the lowest can not be lower than the scale line, and the oil level is usually added to the middle of the two scales. Because when the oil in the engine oil pan is insufficient, the friction between the bearing and the journal will be poor lubrication due to the small amount of oil, aggravate the degree of wear, and even cause the burning of the tile shaft accident. However, if there is too much oil, the crankshaft handle and the big end of the connecting rod of the engine will produce severe agitation when the engine is working, which not only increases the internal power loss of the engine, but also increases the oil splashed on the cylinder wall, resulting in burning and discharging oil failure. Therefore, the oil in the engine oil pan should be controlled between the upper and lower lines of the oil gauge.

7

The circle is waxed the wrong way

8

The correct waxing method is a straight line, alternating horizontal and vertical lines, and then the last one according to the direction of rain flow, so as to achieve the effect of reducing the circular halo on the surface of the car paint. Many people often wax the body in a circle, which is not the correct way.

9

This page is an illegal climb taken from experience

Recommendation